Development and study of a hardening-stabilizing treatment technology for low-rigidity parts of the torsion shaft type

More works in this specialty

1. Improving the efficiency of deep-hole machining through the use of an inertial lever-type burnishing device

   Shchegolev, Nikolay Grigoryevich · 2013 · Candidate of Sciences · Volgograd State Technical University

   • 05.02.07 Technology and equipment of mechanical and physicotechnical processing
2. Increasing the efficiency of the hydraulic feed drive of process equipment

   Le Chung Kien · 2013 · Candidate of Sciences · Don State Technical University

   • 05.02.07 Technology and equipment of mechanical and physicotechnical processing
3. The effect of internal stresses in tool hard alloys on the performance of assembled tools

   Chuikov, Sergey Sergeevich · 2013 · Candidate of Sciences · Tyumen State Oil and Gas University

   • 05.02.07 Technology and equipment of mechanical and physicotechnical processing
4. Optimization of the design parameters of metal-cutting machine tool columns based on a functional quality criterion

   Htay Zar Cho Nweingt · 2013 · Candidate of Sciences · Bauman Moscow State Technical University

   • 05.02.07 Technology and equipment of mechanical and physicotechnical processing
5. Improving the efficiency of multifunction machine tools based on identification of dynamic constraints of milling modes

   Zhmurin, Vladimir Viktorovich · 2013 · Candidate of Sciences · Tula State University

   • 05.02.07 Technology and equipment of mechanical and physicotechnical processing

All works in this specialty